Specifications: Refer to page Manual transmission, automatic — — Lifetime fluid, no fluid change transmission and differential required Online Edition for Part No. Once high enough to get under, make sure to put a jack stand beneath the front part of the cross member place it on a point where you can still access the drain bolt. Strategically place the oil catch pan underneath. Do not wash out bearings. Let the Oil completely drain for a good 10 mins or so. Online Edition for Part No. Install the new O-Ring and Replace the oil filter.
Tightening Torque, refer to Steering Specifications. If equipped with headlight washers or park distance control reconnect hoses and harness. Online Edition for Part No. Remove the large O-Ring on the cap which is located at the top to seal it. It's the only bolt you can see.
And also, you can't miss it since the oil pan is a big square. The range of available displays varies according to your individual car's equipment. It will pay for itself in one use and you will forever swear at Haynes manuals. Edit: Heh, Steven got in there while I was googling and reading. If you exceed or fall below the pro- grammed speed for an extended pe- riod by depressing the accelerator, for example.
. This will aid in not dropping the bolt in the oil pan and not having oil all over your hand. Brace on hexagon socket if necessary. Online Edition for Part No. But since oil changes in an in-line 6 are so easy, try this.
Sorry I can't link straight to the BavAuto product page, their site doesn't allow it. Locate the drain bolt which will be facing downwards at an angle. The wipers sition when released. I found this out the hard way. Use both hands to press the cover se- curely onto the rim. Drive only at walk- ing speed.
Also email Mike Miller of Tech Talk fame techtalk roundel. Online Edition for Part No. Do not place jack stands under suspension oarfs. When loosening the bolt, push on the bolt until you are ready to remove it what this does is that you don't want to just straight loosen the bolt till it falls off. Then apply the lug wrench and turn it to the left refer to the illustration. Online Edition for Part No. I can't find the awnser in this manual.
Version with factory marking above the swivel bearing. Open left side trim panel. Online Edition for Part No. It is a fine car and with proper maintenance it will serve you well. Tapered spigot and bore both free of grease. It will pay for itself in one use and you will forever swear at Haynes manuals. Remove brake disk brake line remains connected , refer to Brakes and Traction Control; Disc Brake System.
Then get your 36mm socket out and begin to remove the oil filter cap. Remove the filter just by pulling it out. Tigten oil cap and start engine. Clean off drain bolt and replace the crushable copper washer new washer is included in your filter kit. Online Edition for Part No. Then get your 36mm socket out and begin to remove the oil filter cap.