A lower, less forceful energy level is provided for more common, moderate-severity impacts. See Guarding against exhaust fumes in this chapter for more instructions. If your vehicle has tires of a different size than the size indicated on the vehicle placard or tire inflation pressure label, you should determine the proper tire inflation pressure for those tires. They ran diagnostics and could not replicate problem. A difficulty with the system is indicated by one or more of the following. Temperature selection: Controls the temperature of the airflow in the vehicle.
Otherwise, random play will begin when the current track is finished playing. Slide on rod feature The visor will slide back and forth on the rod for increased sunlight coverage. If the fuel filler cap is venting vapor or if you hear a hissing sound, wait until it stops before completely removing the fuel filler cap. Note: Engine can not be running to change the state of Autolamp or Rear Park Assist when not in Reverse. Do not tow your All Wheel Drive vehicle with the front wheels off the ground by using a tow dolly and the rear wheels on the ground. When not in a Menu, the left and right cursor controls decrease and increase the display brightness.
After an accident, if the engine cranks but does not start, this switch may have been activated. You must distribute the load in your trailer so that 10%—15% of the total weight of the trailer is on the tongue. In some states in the U. Press again to display cabin temperature settings. Turn signal: Illuminates when the left or right turn signal or the hazard lights are turned on. Pull up on the recliner handle located on the outboard side of the seat to fold the front passenger seatback. After airbag deployment, it is normal to notice a smoke-like, powdery residue or smell the burnt propellant.
Always sit upright against your seatback, with your feet on the floor. This will activate the obstacle detection feature. I hope this was helpful! Use of any tire or wheel not recommended by Ford can affect the safety and performance of your vehicle, which could result in an increased risk of loss of vehicle control, vehicle rollover, personal injury and death. Push the control button located above the liftgate outside handle to unlatch and power open the liftgate. Note: Please refer to local regulations when disposing of transmitter batteries. Our data suggests an early defect trend, as owners of the 2007-2008 models have started posting their accounts of what happens when you're driving down the road and the engine just stops. Once the engine temperature cools, the engine can be re-started.
When the brakes have cooled down, the system will again function normally. Go to the front of the vehicle and release the secondary hood latch that is located under the front center of the hood. This will also prevent passengers and cargo from falling out. If there is visible corrosion in wheel pilot hole, remove loose particles by wiping with clean rag and apply grease. In this guide, answers to such questions are contained in comments highlighted by the warning triangle symbol. Follow your local authorized standards for disposal.
Note: The system may take a few moments to turn on. Failure to activate your headlamps under these conditions may result in a collision. The drivers primary responsibility is the safe operation of their vehicle. The seat heater may cause burns even at low temperatures, especially if used for long periods of time. If you must drive with the liftgate door open, keep the vehicle well ventilated so outside air comes into the vehicle.
Ford strongly recommends that drivers use extreme caution when using any device that may take their focus off the road. The indicator lamp is located in the center stack of the instrument panel above the climate controls. To install floor mats that have a retention post: Position the floor mat so that the eyelet is over the pointed end of the retention post and rotate forward to. Move the seat as far forward as possible. Turn the heater fan on in both vehicles to protect from any electrical surges. Refer to Category Mode under Menu for further information.
Start the engine of the booster vehicle and run the engine at moderately increased speed. Fan speed adjustment: Controls the volume of air circulated in the vehicle. The design and development of the side airbag system included recommended testing procedures that were developed by a group of automotive safety experts known as the Side Airbag Technical Working Group. Do not block the sensors on the front and back of the interior rear view mirror since this may impair proper mirror performance. Extended warranties are also available! Rotate to the second position to turn on the headlamps.